DS-H7 Plate heat exchanger

1,Sealing gaskets does not appear; 2,Advanced plate structure; 3,Advanced frame structure; 4,Solid plate thickness; 5,2.5Mp

We can make according to your requirements!

Introduction

Plate heat exchanger consists of a set of corrugated metal plates, plate with a hole for the heat transfer fluid throughthe two metal plates mounted on a side pressed by the fixed plate and activities within the framework of the board, and with clamping bolt clamping. Plate is equipped with a gasket, sealing the fluid channel and guide the fluid to flow alternately to each channel. Fluid to flow, physical properties, pressure drop and temperature difference determines the existence of discrete plate number and size. Corrugated board not only improve the flow degrees, and the formation of a number of support points, enough to withstand the pressure difference between the media.

 Structure

1,fixed pressure; 2, forestand plate; 3, heatexchanger plate; 4, back head; 5, movable pressureplate; 6, top guide bar

7, under guide bar; 8, rear pillar; 9, fish bolt; 10, connector

Material of plate and gasket seal

A. Plate material (all plank both by the electrolytic polishing processing)

Stainless steel: A1S1, 304SS(1.4301); A1S1, 316SS (1.4401); A1S1, 316T1 (1.4571)Titanium EditionPlatinum Hastelloy Hastelloya special stainless steel SMO254alloy UNS N08904 (1.4539)

B. Gasket materialNBR (NBR, H-NBR)EPDM rubber (EPDM, RPDM-NT, EPDM-HT)Viton (FPM)chloroprene rubber (CR)Special rubber (Viton, Buty1, PTFE-Covered, etc.)

Framework material and interface material

A.Framework Materialpainting steelStainless steelB.Interface MaterialStandard: NBR NBR, EPDM rubber EPDM, stainless steel A1S1 316Special: alloy steel SMO254, Hastelloy Hastelloy Titanium Titanium Platinum

Series

 Technical parameters

 

Pictures

Thank you for your inquiry!

DS-H7 Plate heat exchanger